Kenwood KAC-X501F User Manual

If the front panel gets dirty, turn off the power and wipe the panel with a dry silicon cloth or soft cloth.

List of included accessories for the amplifier.

Guidelines for installing the amplifier, including placement and heat dissipation.

Description of fuses, terminals, and input/output jacks on the amplifier.

Selects the input method for signals to be amplified by amplifiers A and B.

Adjusts the sensitivity according to the pre-out level of the center unit.

Selects amplification methods for signals input to amplifiers A and B.

Applies high-pass or low-pass filtering to speaker outputs.

Sets the cutoff frequency when the FILTER switch is set to HPF.

Sets the cutoff frequency when the FILTER switch is set to LPF.

Cuts frequencies below the set value to remove unwanted vibrations.

Selects bass boost mode and control source for bass boost and slide panel.

Adjusts the central frequency for bass emphasis.

Opens or closes the slide panel.

Indicates when the unit's power is turned ON.

Indicates when the cooling fan is activated and the slide panel opens.

Shows normal operation or indicates activation of protection function.

Indicates when the power voltage falls below 11V.

Glows when the bass boost is turned ON using the B.M.S.

Explains the protection function and its causes, like short circuits or overheating.

Instructions for connecting power wires, including fuse and wire gauge recommendations.

Guidelines for selecting speakers based on impedance and power ratings.

Example setup for a 4-channel system with a subwoofer.

Example setup for a system with high-pass and subwoofer.

Explains frequency band division using coil/capacitor and provides calculation formulas.

Example calculation for crossover frequency and important cautions for tri-mode setup.

Troubleshooting steps for when there is no sound from one or both sides.

Troubleshooting steps for incorrect output levels (too low or too high).

Troubleshooting steps for distorted sound quality.

Troubleshooting steps for unexpected slide panel movement.

Troubleshooting steps for when the B.M.S. controller does not work.

Detailed specifications for power output, frequency response, and distortion.

Details on operating voltage, current consumption, dimensions, and weight.