Need help?Do you have a question about the Kenwood KDC-MP436U and is the answer not in the manual?
FM Tuner Section| frequency range (50 kHz space) | 87.5 MHz – 108.0 MHz |
|---|---|
| frequency range (200 kHz space) | 87.9 MHz – 107.9 MHz |
| usable sensitivity (S/N = 30dB) | 9.3dBf (0.8 μV /75 Ω) |
| quieting sensitivity (S/N = 50dB) | 15.2dBf (1.6 μV /75 Ω) |
| frequency response (±3.0 dB) | 30 Hz – 15 kHz |
| signal to noise ratio (MONO) | 70 dB |
| selectivity (±400 kHz) | ≥ 80 dB |
| stereo separation (1 kHz) | 40 dB |
AM Tuner Section| frequency range (9 kHz space) | 531 kHz – 1611 kHz |
|---|---|
| frequency range (10 kHz space) | 530 kHz – 1700 kHz |
| usable sensitivity (S/N = 20dB) | 28 dBμ (25 μV) |
CD Player Section| spindle speed | 1000 – 400 rpm (CLV 2times) |
|---|---|
| frequency response (±1 dB) | 10 Hz – 20 kHz |
| total harmonic distortion (1 kHz) | 0.008 % |
| signal to noise ratio (1 kHz) | 110 dB |
| dynamic range | 93 dB |
Audio Output| maximum output power | 50 W x 4 |
|---|---|
| full bandwidth power (at less than 1% THD) | 22 W x 4 |
| speaker impedance | 4 - 8 Ω |
| preout level / load (during disc play) | 2500 mV/10 kΩ |
| preout impedance | ≤ 600 Ω |
USB Interface| usb standard | USB1.1/ 2.0 |
|---|---|
| file system | FAT16/ 32 |
| maximum supply current | 500 mA |
Auxiliary Input| frequency response (±1 dB) | 20 Hz – 20 kHz |
|---|---|
| input maximum voltage | 1200 mV |
| input impedance | 100 kΩ |
General Specifications| operating voltage (11 – 16V allowable) | 14.4 V |
|---|---|
| current consumption | 10 A |
| installation size (W x H x D) | 182 x 53 x 155 mm |
| weight | 1.40 kg |
To Next Page