To Next PageTo Next Page
Need help?Do you have a question about the Kenwood KGC-6042A and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Frequency Bands | 7 |
| Subwoofer Output | Yes |
| Type | Graphic Equalizer |
| Signal-to-Noise Ratio | 95 dB |
| Bands | 60 Hz, 150 Hz, 400 Hz, 1 kHz, 2.4 kHz, 6 kHz, 15 kHz |
| Frequency Range | 20Hz - 20kHz |
To prevent fire and avoid personal injury in case of accidents.
To keep the unit in proper working order.
Guidance for installation difficulty and proper cleaning procedures.
Describes the 9+2 and 11 band systems for adjusting front and rear speakers.
Allows adjustment of specific frequencies within set ranges for improved acoustics.
Enables level adjustment across nine frequency bands.
System to control output level and cut-off frequency of sub-woofers.
Allows adjustment of the balance between front and rear speakers.
Enables switching the illumination color between green and orange.
Using the 9+2 band system to adjust front and rear speakers independently.
Using the 11 band system for combined front and rear speaker adjustment.
Instructions on how to activate the parametric equalizer and check the indicator.
Instructions on how to deactivate the parametric equalizer and check the indicator.
Conditions affecting the adjustment range when both equalizers are ON.
Steps for setting and adjusting the high band parametric equalizer frequency.
Steps for setting and adjusting the low band parametric equalizer frequency.
Instructions on how to activate the graphic equalizer and check its indicator.
Instructions on how to deactivate the graphic equalizer and check its indicator.
How to increase or lower the level for specific frequency bands.
Conditions affecting the adjustment range when both equalizers are ON.
Activating the sub-woofer system and its indicators.
Deactivating the sub-woofer system and ceasing output.
Instructions for increasing or lowering the sub-woofer output level.
Instructions for increasing or lowering the sub-woofer cut-off frequency.
Details on speaker output cut-off behavior when the sub-woofer system is ON.
How to rotate the fader control knob counterclockwise to emphasize front speakers.
How to rotate the fader control knob clockwise to emphasize rear speakers.
The fader does not affect sub-woofer output to prevent spillover.
Steps for disconnecting battery, making connections, installing unit, and important safety cautions.
Describes the illumination slide switch for selecting green or orange indicator lights.
The color of the front panel knobs cannot be changed.
Diagram illustrating connections to power amplifiers, speakers, and subwoofer.
Details on connecting power supply leads, battery, and ground to the vehicle chassis.
Crucial warning about preventing fires by correctly connecting power supply and ground leads.
Guidance on using an optional RCA extension cord as a ground wire.
Guidance on selecting a safe location and using supplied mounting accessories.
Visual representation of how to mount the unit using brackets, screws, and straps.
Troubleshoots power issues, including blown fuses and improper power supply connections.
Addresses no sound from front/rear speakers due to fader or connection issues.
Diagnoses problems with not hearing low frequencies, often related to subwoofer settings.
Details equalizer center frequencies and equalization range.
Lists cut-off frequency, gain, and slope for the sub-woofer system.
Provides frequencies and equalization range for the parametric equalizer.
Includes input/output impedance, S/N ratio, THD, frequency response, and gain.
Covers operating voltage, current consumption, installed size, and weight.
