Need help?Do you have a question about the Kenwood KR-200HT and is the answer not in the manual?
General| Tuning range | FM, MW |
|---|---|
| Frequency response | 20Hz to 20kHz |
| Tuner Type | Analog |
| Number of Channels | 2 |
| Input sensitivity | 2.5mV (MM) |
| Speaker load impedance | 4-16 ohms |
| Speaker Impedance | 4-16 ohms |
Explains how to set the AC voltage selector switch based on region.
Lists critical safety warnings and precautions for the user.
Instructions on how to unpack the unit and check for damage.
Lists the included accessories with the unit.
Describes surround sound modes for realistic audio effects.
Explains the SRS system for simulating a 3D sound space.
Illustrates how to connect audio and video components to the receiver.
Details connecting KENWOOD components for system control operations.
Illustrates how to connect front, center, and surround speakers to the unit.
Guides on connecting AM loop and FM indoor/outdoor antennas.
Explains the switch setting for different regions regarding FM reception.
Details the functions of the various keys on the remote control.
Instructions on how to load batteries into the remote control.
Outlines operating procedures and a table for remote control key functions.
Guides on adjusting bass, middle, and treble frequencies.
Guides on adjusting the left/right speaker balance.
Guides on preparing for recording and selecting music sources.
Details tape dubbing and using the TAPE 2 MONITOR function.
Steps for tuning into FM and AM radio stations.
Guides on tuning to specific frequencies using numeric keys.
Explains how to store radio stations in memory using preset numbers.
Guides on recalling stored radio stations using preset numbers.
Describes how to sequentially receive all stored preset stations.
Instructions for playing back videotapes.
Guides on recording video sources to a video deck.
Explains Dolby surround modes for immersive audio experiences.
Provides guidelines for optimal surround speaker placement.
Guides on selecting the center speaker mode (Normal, Wideband, Phantom).
Instructions for adjusting the balance between left and right front speakers.
Instructions for selecting desired surround sound modes.
Steps to turn off surround play and return to stereo mode.
Guides on adjusting the tone controls for SRS 3D effect.
Guides on adjusting the strength (level) of the SRS 3D effect.
Details how to reset the microcomputer to its factory condition.
Lists common amplifier and tuner problems, causes, and remedies.
Addresses issues with remote control operation and possible causes.
Explains items deleted from memory when power is disconnected.
Details technical specifications for the audio output section.
Lists technical specifications for the FM and AM tuner sections.
Provides general operational specs and video input/output details.
Lists technical specs for audio and tuner sections for international markets.
Provides general operational and video specs for international markets.
To Next Page
