Need help?Do you have a question about the Kenwood KR-A5040 and is the answer not in the manual?
General| Power Output | 70 watts per channel into 8Ω (stereo) |
|---|---|
| Frequency Response | 20Hz to 20kHz |
| Input Sensitivity | 2.5mV (MM), 200mV (line) |
| Signal-to-Noise Ratio | 75dB (MM), 100dB (line) |
| Tuning Range | FM, MW |
| Dimensions | 440 x 127 x 305mm |
| Weight | 7.3kg |
| Speaker load impedance | 8 ohms |
| Signal to noise ratio | 75dB (MM), 100dB (line) |
Record serial number for dealer information or service.
Check for shipping damage and retain packing materials.
Important notes on voltage and shock prevention.
Important notes on voltage and mains plug wiring.
Important notes on voltage for Australia and Europe.
AC voltage selector switch explanation.
Connect speakers rated at 4 ohm or more to terminals.
Set IMPEDANCE SELECTOR according to speaker impedance.
Notes on using AC outlets for power supply to other components.
Indoor antenna placement and connection.
Using a vinyl-coated wire for outdoor AM reception.
Indoor antenna for stable FM reception.
Recommends exclusive FM outdoor antenna for high quality.
Controls for selecting speaker systems A and B.
Step-by-step guide for basic unit operation.
Explanation of Tone, Balance, Loudness, and Power Standby.
Steps to tune in and listen to radio broadcasts.
Explains auto tuning and manual tuning for radio stations.
Connecting the receiver and operating it with the remote.
Describes the approximate operating range of the remote.
Instructions for inserting batteries into the remote.
Making connections using system control cords.
Ensuring correct audio and system control cord connections.
Explains automatic play and synchro recording.
To Next Page
