Need help?Do you have a question about the Kenwood KT-595 and is the answer not in the manual?
General| Tuning Bands | FM, MW |
|---|---|
| Signal to Noise Ratio (AM) | 50dB |
| Tuning Scale | Analogue |
| FM Tuning Range | 87.5 - 108 MHz |
| Signal to Noise Ratio (FM) | 70 dB |
| Distortion (FM) | 0.3% |
| Frequency Response (FM) | 30 - 15, 000 Hz |
Selects the correct AC voltage for the unit's operation based on region.
Switch for selecting FM de-emphasis and channel spacing based on region.
Explains the standby mode where a small current is supplied for memory backup.
Remembers and automatically tunes to the last received station upon power-on.
Retains preset station memory for up to three days when power is unplugged.
Procedure to reset the microcomputer in case of erroneous display or operation.
Connects to an amplifier for system operation and remote control.
Details the types of AC outlets and their power ratings on the rear panel.
Guides on tuning stations and saving them into memory presets.
Instructions to reset the microcomputer by unplugging and replugging the power cord.
Note for CATV system installer regarding grounding guidelines.
Warning about potential radio frequency energy and interference.
Details compliance with FCC rules for Class B digital devices and interference mitigation.
To Next Page
