Kenwood TH-26A User Manual

4-7. CHANNEL DISPLAY MODE
Channels can be shown on the display.
(Ex)
[N
,
f
1. Enter the desired operating
frequency into memory. (0'
4-4-4. Memory Entry, 4-4-8.
Automatic Memory Initial-
ization)
2. Turn off the transceiver
POWER switch.
3. If you press and hold the
MaN I switch while you turn
on the POWER switch.
POWER OFF
(0
POWER ON
+ (0
NONl
!c:=ll
To return to the frequency mode , repeat the same
operation (steps 2 and 3 above).
Note
In th e channel display mode only the following
functio ns are valid:
• MON I, PTT , LAMP switch, F key
• Fun ct ions shaded L:=J in the table below.
~
[Ij
[Ij( lse d
~+
(1 Sec)
~ ~
Power On
-
MHz
MHz SCAN STEP MHz SCAN AUTO MEMO
VFO VFO SCAN M. SHIFT Vi M SCAN VFO RESET
MR M. SCAN
M.IN LOCK OUT
M.CLR
--
T.ALT
BEEP
TO/CO
SAVE
-
CALL CALL SCAN
CALL IN
V/M/C SCAN A.P.O
REV SHIFT DELAY UPP ER SET
S HIFT
DTSS CODE SEL LOWER SET
,20 NE/CTCSS
TONE SEL
MICSW
35

Kenwood TH-26A Specifications

General

Brand	Kenwood
Model	TH-26A
Category	Transceiver
Language	English