To Next PageTo Next Page
Need help?Do you have a question about the Kenwood XR600-6DSP and is the answer not in the manual?
General| Number of Channels | 6 |
|---|---|
| Maximum Power Output | 1200W |
| RMS Power Output (4 Ohms) | 75W x 6 |
| Power Output (4 Ohms) | 75W x 6 |
| RMS Power Output (2 Ohms) | 100W x 6 |
| Power Output (2 Ohms) | 100W x 6 |
| Bridged RMS Power Output (4 Ohms) | 200W x 3 |
| Power Output (4 Ohms Bridged) | 200W x 3 |
| Frequency Response | 20Hz - 20kHz |
| Signal-to-Noise Ratio | 100dB |
| Crossover Slope | 12dB/octave |
| Input Sensitivity | 0.2V - 5V |
| DSP | Yes |
| Built-in DSP | Yes |
| Built-in Crossover | Yes |
| Total Harmonic Distortion (THD) | 0.05% |
| Dimensions | 215mm x 53mm x 170mm |
| Power Output | 75 Watts x 6 at 4 Ohms |
| DSP Features | Time Alignment |
| Inputs | RCA |
| THD | 0.05% (1kHz) |
Covers warnings about injury, fire, and unit heat to prevent accidents.
Explains the unit's protection features against short circuits, DC signal, and overheating.
Provides essential instructions for connecting power, ground, and speaker wires safely.
Details on choosing speakers with appropriate input ratings and impedance.
Step-by-step instructions for connecting wires and mounting the unit.
Important warnings regarding installation locations and potential hazards.
Critical warnings about electrical contact at amplifier and speaker terminals.
Instructions for installing the Weblink plugin required for the product.
Steps to create and validate a Weblink account for programming.
Procedure for connecting the module to a PC using a USB cable.
Guidance on logging in, flashing the module, and downloading the install guide.
