To Next Page

To Previous Page

ELECTRICAL CONNECTION

Themainspowersupplymustcorrespondtotheratingindicatedontheplate

situatedinsidethehood.Ifprovidedwithaplugconnectthehoodtoasocket

incompliancewithcurrentregulationsandpositionedinanaccessiblearea,

afterinstallation.Ifitnotfittedwithaplug(directmainsconnection)orifthe

plug is not located in an accessible area, after installation, apply adouble

pole switch in accordance with standards which assures the complete

disconnectionofthemainsunderconditionsrelatingtoover-currentcategory

III,inaccordancewithinstallationinstructions.

Warning! Before re-connecting the hood circuit to the mains supply

andchecking the efficient function, always check that the mains cable

iscorrectlyassembled.

The hood is provided with aspecial power cable; if the cable is damaged,

requestanewonefromTechnicalService.

MOUNTING

Expansion wall plugs are provided to secure the hood to most types

of walls/ceilings. However, aqualified technician must verify suitability

ofthematerialsinaccordancewiththetypeofwall/ceiling.Thewall/ceiling

must be strong enough to take the weight of the hood. Do not tile, grout

orsiliconethisappliancetothewall.Surfacemountingonly.

Kernau KCH 1461 X User Manual

Questions and Answers: