What to do if my Kessel Lifting Systems pump becomes hot and switches off?
If your Kessel Lifting Systems pump gets hot and switches off, raise the pressure pipe to more than 0.5 m pumping height. Alternatively, consider installing a replacement impeller, keeping in mind that this will slightly reduce the pumping height.
Why is the impeller blocked in my Kessel Aqualift S?
If the impeller is blocked in your Kessel Lifting Systems, it may be due to soiling, solids, and coarse materials jammed between the impeller and suction flange. To resolve this, clean the pump as described in chapter 3.
How to troubleshoot Kessel Aqualift S Lifting Systems pump not running?
If your Kessel Lifting Systems pump is not running, check the mains voltage and replace the fuse if necessary. For more complex issues, repairs should only be carried out by KESSEL customer service. You can also try replacing the complete floating switch (art. no. 28012) or have it repaired through KESSEL customer service. Additionally, ensure the ventilation bore hole is clean.
What to do if Kessel Aqualift S Lifting Systems has reduced pumping capacity?
If you experience reduced pumping capacity with your Kessel Lifting Systems, try cleaning the pump as described in chapter 3. If the issue persists, consider replacing the suction flange or the impeller. Also, ensure the ventilation bore hole is clean.
Lists key features of the KESSEL Aqualift S lifting station.
Defines the intended use of the KESSEL lifting station for soiled water disposal.
Details the KESSEL Aqualift S lifting station's resistance and components.
Specifies connection types and requirements for the lifting station.
Instructions for horizontally aligning the pump tank and attaching side inlets.
Guides on tiling or laying natural stone on the cover plate.
Details using extension pieces for recessed ground plate installation.
Explains how to seal the lifting station for installation in water load conditions.
Instructions for free-standing setup and securing the above-ground lifting station.
Guidance on installing the pump separately packed before initial operation.
Procedure for setting the probe height for the control unit.
Ensures correct distance between submersible pipe and tank bottom.
Details on correctly positioning the alarm probe for the system.
Illustrates a suggested installation setup with layers and components.
Step-by-step guide to safely remove the pump from the lifting station.
Procedure for cleaning sealing surfaces and correctly installing the pump.
General servicing tasks, including pump checks and electrical connection verification.
Instructions for removing and cleaning the integrated backwater valves.
Information on using the KTP 500 pump and required electrical safety measures.
Provides detailed diagrams with dimensions for different Aqualift S models.
Presents a capacity diagram and technical specifications for the KTP 500 pump.
General| Pump Type | Submersible |
|---|---|
| Application | Lifting wastewater |
| Installation | For free-standing installation |
| Type of wastewater | Faecal-free wastewater |
| Installation type | Free-standing installation |
To Next Page
