Kestrel 1000 User Guide

6
Turning ON and OFFxx
• Press to turn on.
• Hold for 3 seconds to turn o.
The Kestrel Meter will automatically turn o if no buttons
have been pressed for 45 minutes.
Select Measurement Mode
• Use or to access each Measurement screen
• The instantaneous Measurement value will be
displayed on each screen and updated once per
second.
Each Measurement screen will ash a brief “Hint” to clarify
which Measurement is being displayed. Note: Hints are not
displayed in the Kestrel 1000.
The Measurement’s icons and units of measure will be
displayed in the lower line of the screen.
75.2
°F °F
Temperature “Hint”
ashes before
Temperature
Measurement Screen
Select the Unit of Measure
• Select the unit of measure. While holding ,
press
to scroll through the available units
of measure for that measurement.
Adjust the Clock
*This applies to the 2500, 2500NV, 3500, 3500NV and 3500DT.
• Adjust the clock. Simultaneously press and
to access clock setting. While the time is
blinking, press or to change the time.
Hold either button down to adjust quickly.
Simultaneously press and to exit clock
setting.
GETTING STARTED
SETUP + OPTIONS
Shop for Quality products online at:
1.800.561.8187
www.SCOUTBASECAMP.ca

Kestrel 1000 Specifications

General

Brand	Kestrel
Product Category	Measuring Instruments
Measures	Wind Speed
Wind Speed Range	0.6 to 40 m/s
Wind Speed Resolution	0.1 m/s
Display	LCD
Power Source	CR2032 Coin Cell Battery
Water Resistance	IP67
Type	Anemometer
Wind Speed Accuracy	±3%
Units of Measure	m/s, km/h, mph, knots, ft/min
Temperature Range	-29 to 70°C
Temperature Accuracy	+/- 1° C