Press any button to power on.
Place a large mug (10 oz minimum) on
the drip tray.
Follow the instructions on the brewer screen
to perform a cleansing brew.
Do not remove the water reservoir once the brew button has been
pressed until the brew has been completed. The one-time setup
process is now complete and you are ready to brew!
5
6
7
Before You Brew
Rinse & Fill
Clean the Frother
Cleansing Brew
Rinse reservoir with fresh water
and fill to the Max fill line.
If you have a Keurig® Water Filter, install it now.
NOTE: Do not use distilled water.
Remove the lid and whisk from inside the frother.
Wash the interior of the frother, lid, and whisk
with warm, soapy water. Dry all parts thoroughly
using a soft, nonabrasive cloth, then reassemble.
NOTE: Frother is not dishwasher safe. Do not
submerge frother in water. Only use nonabrasive
cleaning materials to prevent damage to the inner
surface of the frother. Dry interior of frother and
base with a soft cloth after cleaning.
To Next Page