Remove packing tape from brewer
and plug into an outlet.
Single Cup - Place a large mug
(12oz minimum) on the drip tray.
Carafe - Rinse the carafe and
place it on the heating plate.
Remove the water reservoir lid, then lift
the reservoir straight up to remove it.
If you have a Keurig
®
Water Filter, install it
now. Refer to your Water Filter Starter Kit
for instructions.
Fill the reservoir with fresh water to the
MAX fill line.
Replace water reservoir, making sure the
lock tabs engage with the brewer.
Press the OZ button to power on the
single cup side. Do not insert a K-Cup®
pod. Press the 8 button to start
the cleansing brew – the OZ button
will pulse green while the brewer is
heating. Once heated, the OZ button
will turn solid green and the cleansing
brew will begin. Pour the hot water
into the sink.
NOTE: Between brew cycles, the brewer may take about a
minute to reheat
1
3
5
2
Before You Brew
The CUPS button will illuminate red to
indicate the heating plate is on when
the cleansing brew is complete. Press
and hold the CUPS button to turn the
heating plate off, and pour the hot
water into the sink.
The one-time single cup setup process
is now complete and you are ready to
brew!
Press the 8 button to start a
cleansing brew – the button will
illuminate blue.
Add Water
8
Add Water
Add Water
Add Water
8
Add Water
12
10
8
Add Water
12
10
8
Plug & Place Rinse & Fill
Cleansing Brew - Single Cup
Fill the reservoir to the MAX fill line, and
then press the CUPS button to power on
the carafe side. Do not fill filter basket
with coffee grounds. The CUPS button
will illuminate green and the 3 brew size
buttons will blink blue.
4
Power On - Carafe
Cleansing Brew - Carafe
HEATING
PLATE
ON
To Next Page
Loading...
