To Next PageTo Next Page
Need help?Do you have a question about the Key Automation 900RXI-41 and is the answer not in the manual?
Descriptions for 900RXI-41/42 and 900RXM-41/42 models, featuring self-learning and non-volatile memory.
Descriptions for 900RXI-41R/42R and 900RXM-41R/42R models, with self-learning and reduced memory capacity.
Specifications for the 900RXM230-42 receiver, operating on 230 Vac with self-learning.
Receiver performs internal test on power-up; LEDs LR1-LR2 flash to indicate readiness.
How to enter self-learning mode, transmit codes, and confirm memorization with LED feedback.
Using pushbuttons S and P to select outputs and set monostable, bistable, timed, or ON-OFF modes.
Steps to delete specific or all codes using pushbuttons P and S.
How to perform a complete memory reset by holding pushbutton P.
Press a memorized radio control for at least 15 seconds to initiate learning.
Press the new radio control within 10 seconds to memorize its code.
Output toggles status with each command; deactivated on power failure.
Output remains active for a fixed interval (20 or 40 seconds).
Specific channels activate ON or OFF; requires simultaneous memorization.
Configuration option for selecting voltage at 12Vdc/Vac.
Recommendations for optimal radio control reception and aerial setup.
Instructions to find local recycling methods for product components.
Descriptions for 900RXI-41/42 and 900RXM-41/42 models, featuring self-learning and non-volatile memory.
Descriptions for 900RXI-41R/42R and 900RXM-41R/42R models, with self-learning and reduced memory capacity.
Specifications for the 900RXM230-42 receiver, operating on 230 Vac with self-learning.
Receiver performs internal test on power-up; LEDs LR1-LR2 flash to indicate readiness.
How to enter self-learning mode, transmit codes, and confirm memorization with LED feedback.
Using pushbuttons S and P to select outputs and set monostable, bistable, timed, or ON-OFF modes.
Steps to delete specific or all codes using pushbuttons P and S.
How to perform a complete memory reset by holding pushbutton P.
Press a memorized radio control for at least 15 seconds to initiate learning.
Press the new radio control within 10 seconds to memorize its code.
Output toggles status with each command; deactivated on power failure.
Output remains active for a fixed interval (20 or 40 seconds).
Specific channels activate ON or OFF; requires simultaneous memorization.
Configuration option for selecting voltage at 12Vdc/Vac.
Recommendations for optimal radio control reception and aerial setup.
Instructions to find local recycling methods for product components.
General| Brand | Key Automation |
|---|---|
| Model | 900RXI-41 |
| Category | Receiver |
| Language | English |
