3. In 2.4GHzparingmode, the mouse indicator will slowly blink greenfor 3 minutes. If the mouseis not connected within 3
minutes, the indicator will turnoff. f you need to reconnect, hold both the "Left button Forward button" for 4 seconds
tore enter pairing mode.
f you needto repairthe connectionin 2.4GHzmode,pleaseunplugthe 2.4GHzreceiverfirst.Then,hold both the "Left button
+ Forward button" for 4 seconds, wait for the green light indicator to start flashing, and plug the 2.4GHz receiver back in to
completethe pairingprocess.
Note:It is recommended that when pairing the M6 in 2.4GHzmode, the mouseshould be within 20cm of the receiver.
C,'0FF/a
G = 2.4GHZ mode
I Note: For the best wireless experience, we recommend using the
extensionadapterfor receiverand putting the 2.4GHz
receiversomewhereonyour deskcloseto your mousefor
a lower rate of latency and fewer signal interferences.
simultaneouslyhold for 4 seconds
(to enter the forced paring mode)
Type C Cable Extension 2.4GHz
Adapter Receiver
-3
To Next Page
Loading...
