Keychron V6 - Maintenance and Specifications; Factory Reset Procedure; Keyboard Specifications

9
Factory Reset
Troubleshooting? Don’t know what’s going on with the keyboard?
1. Plug the power cable and factory reset the keyboard by pressing fn + J + Z (for 4
seconds)
2. Download the right firmware and QMK Toolbox from our website.
3. Unplug the power cable and remove the space bar keycap to find the reset button
on the PCB.
4. Hold the reset key first, then plug in the power cable. Release the reset key, and
the keyboard will now enter DFU mode.
5. Flash the firmware with the QMK Toolbox.
6. Factory reset the keyboard again by pressing fn + J + Z (for 4 seconds)
Step by step guide can be found on our website.
V6 Customizable Keyboard Specifications
Layout
Full Size
Switch type
Mechanical
Width
140.55 mm
Length
447.85 mm
Front height
19.44 mm (without keycaps)
28.55 mm (with keycaps installed)
Back height
26.83 mm (without keycaps)
37 mm (with keycaps installed)
Keyboard feet height
2 mm
Angle
3.5 / 7.05 / 9.52 degree