DANGER
DANGER indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION used with the safety alert symbol, indicates a hazardous situation which, if not avoided,
could result in minor or moderate injury.
WARNING
CAUTION
NOTICE is used to address practices not related to personal injury.
ELECTRIC SHOCK CAN CAUSE INJURY OR DEATH!
Improper use of an electric Welder can cause electric shock, injury and death! Read all
precautions described in the Welder Manual to reduce the possibility of electric shock.
Disconnect Welder from power supply before assembly, disassembly or maintenance
of the torch, contact tip and when installing or removing nozzles.
Always wear dry, protective clothing and leather welding gloves and insulated
footwear. Use suitable clothing made from durable flame-resistant material to protect
your skin.
Always operate the Welder in a clean, dry, well ventilated area. Do not operate the
Welder in humid, wet, rainy or poorly ventilated areas.
The electrode and work (or ground) circuits are electrically “hot” when the Welder is
on. Do not allow these “hot” parts to come in contact with your bare skin or wet
clothing.
Separate yourself from the welding circuit by using insulating mats to prevent contact
from the work surface.
Be sure that the work piece is properly supported and grounded prior to beginning an
electric welding operation.
Always attach the Ground Clamp to the piece to be welded and as close to the weld
area as possible. This will give the least resistance and best weld.
NOTICE
DANGER
READ INSTRUCTIONS
Thoroughly read and understand this manual before using. Save for future reference.
Electric welding produces sparks which can be discharged considerable distances at
high velocity igniting flammable or exploding vapors and materials.
DO NOT operate electric arc Welder in areas where flammable or explosive vapors
are present.
DO NOT use near combustible surfaces. Remove all flammable items from the work
area where welding sparks can reach (min. of 35 feet).
WELDING SPARKS CAN CAUSE FIRE OR EXPLOSION!
DANGER
Page 03
To Next Page
