Menu Example 2 Some commands in the menu require that you enter a numeric parameter
value. The following steps show you how to enter a number in the menu.
In this example, you will set the calibration value to 0.0 volts. For this
example you must apply a short between
HI-LO Sense and HI-LO Input.
Caution Completing this example will perform a zero calibration. Refer
to chapter 4, “Calibration Procedures,” before attempting this example.
1 Turn on the menu.
You enter the menu on the “menus” level. The
MEAS MENU is your first
choice on this level.
A: MEAS MENU
2 Move across to the CAL MENU choice on this level.
There are six menu group choices available on the “menus” level. Each
choice has a letter prefix for easy identification (A: , B: , etc.).
F: CAL MENU
<
Shift <
On/Off
3
Chapter 3 Menu Tutorial
A Front-Panel Menu Tutorial
55
To Next Page
Loading...
