6 Keysight E36200 Series Service Guide
– TURN DEVICE OFF AND REMOVE ALL CONNECTIONS BEFORE
INSTALLING THE GPIB INTERFACE
Turn off the power and remove all connections, including the power cord,
from the instrument prior installation of the GPIB interface.
– ENSURE PROPER AWG CABLE IS USED
Use a cable with the correct voltage and AWG rating based on the
intended setup when operating the E36200A Series autoranging DC
power supplies.
– DO NOT TOUCH CABLES DURING OPERATION
Do not touch the cable while the instrument output is operational to
prevent electric shock hazard and burn hazard.
CLEAN WITH SLIGHTLY DAMPENED CLOTH
Clean the outside of the instrument with a soft, lint-free, slightly dampened
cloth. Do not use detergent, volatile liquids, or chemical solvents.
CONNECT USB CABLE WITH FERRITE CORE
Connect a USB cable with a ferrite core to the rear panel USB port of the
instrument for better performance.
To Next Page
Loading...
Need help?
General
