Need help?Do you have a question about the Keysight Technologies E364xA Series and is the answer not in the manual?
General| Operating Temperature Range | 0 to 50 °C |
|---|---|
| Storage Temperature Range | -40 to 70 °C |
| Power Rating | 100 W |
| Number of Outputs | 1 or 2 (depending on model) |
| Display | LED |
| Interface | GPIB |
| Programming Accuracy Current | 0.2% + 5 mA |
| Ripple & Noise (20 Hz to 20 MHz) | 1 mVrms |
| Load Regulation Voltage | 0.01% + 2 mV |
| Line Regulation | 0.01% + 2 mV |
| Dimensions (W x H x D) | 8.4 in |
Explains CAUTION and WARNING notices for safe operation.
Provides essential safety rules to follow before and during instrument use.
Step-by-step guide for initial power supply setup, connection, and self-test.
Identifies and describes the functions of the front panel keys and display.
Explains how to set voltage and current limit values from the front panel.
Step-by-step guide for setting up and operating in constant voltage mode.
Step-by-step guide for setting up and operating in constant current mode.
Details on setting up GPIB and RS-232 interfaces for remote control.
Instructions for setting, checking, and clearing OVP trip levels.
Details commands for setting output voltage, current, and ranges.
Lists and explains errors related to command execution and syntax.
Details error codes indicating failures during self-test procedures.
Lists and explains error messages that may occur during calibration.
Detailed electrical parameters including voltage, current, accuracy, and noise.
Guidelines to prevent ESD damage when servicing electronic devices.
Provides a checklist of common failures and potential solutions.
Instructions for performing power-on and complete self-tests.
Lists necessary equipment for performance verification and adjustment procedures.
Information on unsecuring the power supply for calibration and calibration services.
Step-by-step guide for performing front panel voltage, OVP, and current calibration.
To Next Page