3 Remote Interface Reference
90 Keysight E364xA User’s and Service Guide
SCPI Command Summary
This section summarizes the SCPI (Standard Commands for Programmable
Instruments) commands available to program the power supply over the remote
interface. Refer to the later sections in this chapter for more complete details on
each command.
Throughout this manual, the following conventions are used for SCPI command
syntax.
– Square brackets ([ ]) indicate optional keywords or parameters.
– Braces ({ }) enclose parameters within a command string.
– Triangle brackets (< >) indicate that you must substitute a value or a code for
the enclosed parameter.
– A vertical bar ( | ) separates one of two or more alternative parameters.
If you are a first-time user of the SCPI language, refer to Introduction to the SCPI
Language and Simplified Programming Overview to familiarize with the SCPI
language before attempting to program the power supply.
To Next Page
Loading...
