Keysight Technologies E4360A - Page 33

Performance Verification 2
Series E4360 Service Guide 33
Test Record Form – Keysight E4362A-J21
Keysight Model E4362A-J21 Report No _______________ Date __________________
Description Minimum Specs. Results Maximum Specs.
Constant Voltage Tests
Voltage Programming & Readback
Min. Voltage Vout
Voltage measured over interface
High Voltage Vout
Voltage measured over interface
− 44 mV
Vout − 44 mV
104.87725 V
Vout − 128 mV
__________
__________
__________
__________
+ 44 mV
Vout + 44 mV
105.1228 V
Vout + 128 mV
CV Load Effect
− 2 mV
__________ + 2 mV
CV Source Effect
− 2 mV
__________ + 2 mV
CV Ripple and Noise (at full and no load)
peak-to-peak (Fixed mode)
rms (Fixed mode)
peak-to-peak (SAS & Table mode)
rms (SAS & Table mode)
N/A
N/A
N/A
N/A
__________
__________
__________
__________
+ 150 mV
+ 29 mV
+ 178 mV
+ 24 mV
Constant Current Tests
Current Programming & Readback
Min. Current Iout
Current measured over interface
High Current Iout
Current measured over interface
−Current measured over interface (@
0.42 A)
− 14 mA
Iout − 14 mA
6.7225 A
Iout − 27.5 mA
Iout − 34.5 mA
__________
__________
__________
__________
__________
+ 14 mA
Iout + 14 mA
6.7775 A
Iout + 27.5 mA
Iout + 34.5 mA
CC Load Effect
− 1 mA
__________ + 1 mA
CC Source Effect
− 1 mA
__________ + 1 mA
Test Description E4362A-J21 Setting
Voltage Programming & Readback, Min 0 mV, 6.885 A
Voltage Programming & Readback, High 105 V, 6.885 A
CV Load Effect, Source Effect, Ripple and Noise 105 V, 6.885 A; Rload for ripple & noise = 15.5 Ω
Current Programming & Readback, Min 0 mA, 107.625 V
Current Programming & Readback, High 6.75 A, 107.625 V
CC Load Effect, Source Effect 6.75 A, 107.625 V
SAS Curve settings for Ripple and Noise tests Isc = 6.75; Imp = 6.75; Vmp = 105; Voc = 114