Keysight Technologies E4360A - Page 34

2 Performance Verification
34 Series E4360 Service Guide
Test Record Form – Keysight E4362A-J22
Keysight Model E4362A-J22 Report No _______________ Date __________________
Description Minimum Specs. Results Maximum Specs.
Constant Voltage Tests
Voltage Programming & Readback
Min. Voltage Vout
Voltage measured over interface
High Voltage Vout
Voltage measured over interface
 48 mV
Vout  48 mV
114.86575 V
Vout  114 mV
__________
__________
__________
__________
+ 48 mV
Vout + 48 mV
115.1343 V
Vout + 114 mV
CV Load Effect
 2 mV
__________ + 2 mV
CV Source Effect
 2 mV
__________ + 2 mV
CV Ripple and Noise (at full and no load)
peak-to-peak (Fixed mode)
rms (Fixed mode)
peak-to-peak (SAS & Table mode)
rms (SAS & Table mode)
N/A
N/A
N/A
N/A
__________
__________
__________
__________
+ 150 mV
+ 30 mV
+ 189 mV
+ 24 mV
Constant Current Tests
Current Programming & Readback
Min. Current Iout
Current measured over interface
High Current Iout
Current measured over interface
Current measured over interface (@
0.42 A)
 14 mA
Iout  14 mA
6.972 A
Iout  28 mA
Iout  35.5 mA
__________
__________
__________
__________
__________
+ 14 mA
Iout + 14 mA
7.028 A
Iout + 28 mA
Iout + 35.5 mA
CC Load Effect
 1 mA
__________ + 1 mA
CC Source Effect
 1 mA
__________ + 1 mA
Test Description E4362A-J22 Setting
Voltage Programming & Readback, Min 0 mV, 7.14 A
Voltage Programming & Readback, High 115 V, 7.14 A
CV Load Effect, Source Effect, Ripple and Noise 115 V, 7.14 A; Rload for ripple & noise = 16.4 Ω
Current Programming & Readback, Min 0 mA, 117.875 V
Current Programming & Readback, High 7 A, 117.875V
CC Load Effect, Source Effect 7 A, 117.875 V
SAS Curve settings for Ripple and Noise tests Isc = 7; Imp = 7; Vmp = 115; Voc = 124