Keysight CX3300 Series - Page 30

Keysight Technologies
CX3300 Current Waveform Analyzer
Quick Operation Guide
How to set the Trigger
1. Press [Sweep] to set the Trigger to ON.
2. Select the Trigger Type. ( Default: “Edge” )
2-1. Select “Trigger” on the Tool Palette
2-2. Select the Trigger Type ( “Edge” in this case ) from the Trigger Tool
Palette
2-3. Drag-and-drop the icon onto the target waveform. The color of the icon
shows the target waveform.
Trigger Controls
3
The color of the icon shows
the target waveform
1
Trigger summary
2-1
2-3
Drag & drop
2-2
30