Need help?Do you have a question about the Keysight N9912A and is the answer not in the manual?
General| Brand | Keysight |
|---|---|
| Model | N9912A |
| Category | Measuring Instruments |
| Language | English |
Lists available options and features of the FieldFox analyzers and their corresponding sections.
Procedure for inspecting the FieldFox upon receipt for damage and completeness.
Step-by-step instructions for installing the FieldFox lithium-ion battery.
Warns about damage from excessive power/voltage and provides maximum input limits.
Covers settings for Cable and Antenna Test mode, including measurement selection.
Step-by-step guide for performing Distance to Fault measurements.
Details on configuring various settings for DTF measurements.
Explains how to enter cable loss and velocity factor for accurate DTF.
Covers general settings for Network Analyzer mode.
Details settings related to Port Extensions, Velocity Factor, and Media Type.
Describes how to select display formats for measurement results.
Measures loss through a DUT or cable over a specified frequency range.
Covers settings for Time Domain transform, stimulus, and data processing.
Explains the need for calibration and when to perform it.
Details a quick and simple calibration method for jumper cables/adapters.
Calibrates 2-port Insertion Loss and S21 Transmission measurements.
Covers general settings for Spectrum Analyzer mode.
Determines the frequencies measured for each sweep.
Adjusts Y-axis scale and selects units for measurement display.
Measures signal strength using antenna factors for correction.
Measures electrical length of cables and devices using 1-port or 2-port methods.
Details selecting 1-Port Cable Trimming or 2-Port Transmission measurements.
To Next Page
