Keysight N9912A - Fieldfox Package Installer (N9912 A Units with Serial Number Prefixes ≥5607 Only)

18- 20 Keysight N9912-90001 User’s Guide
System Settings
System Configuration
18-
How to set Power ON
—Press System 7.
—Then System Configuration
.
—Then Power ON
.
— Then choose from the following:
— Auto
The FieldFox will power ON when a charged battery or the DC
Adapter is inserted.
— Manual
The FieldFox will power ON only when the power button is
pressed.
FieldFox Package Installer (N9912A units with serial number
prefixes ≥5607 Only
)
The FieldFox Package Installer enables you to download new versions of
firmware from either a USB memory or SD Card. Additionally, the Utility softkey
enables you to backup user files or restore user files.
How to run the Installer
—Press System 7.
—Then System Configuration
.
—Then More
—Then Firmware Update
—Then Start Installer
— The Installer software opens after a couple of seconds.
— Then the arrows or the knob to scroll to the firmware you want to
install.
—Press Start Install
—“Current Step Progress:” bar and a “Total Progress:” bar are
displayed along with this message: “Copying package. Do not
remove install media.”
Before running the Installer to update your firmware, you might want to
back up your user data. Refer to “How to restore files” on page 18-21.
If no files are displayed, verify that a USB memory or SD Card is installed
and press Refresh List
.