Keysight N9912A - Trace Display States

8- 28 Keysight N9912-90001 User’s Guide
SA (Spectrum Analyzer) Mode
SA Mode Settings
8-
— Then choose from: 101 | 201 | 401 | 601 | 801 | 1001.
Trace Display States
In SA Mode you can display up to four of the following types of trace states. All
SA settings are applied to all displayed traces.
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display the Trace States
—Press Trace 6.
—Then Trace 1,2,3,4
repeatedly to select a trace number to display or change
its state. Traces are displayed in the following colors:
—Trace 1 – Yellow Trace 2 – Blue
—Trace 3 – Orange Trace 4 – Green
—Then State [current setting]
— Then choose from the following Trace States:
— Clr /Wr
(Clear/Write) Displays the actual measured data for each
sweep.
— MaxHold
Displays the maximum response of the input signal at each
data point over multiple sweeps. See also Average Count in “Average
Count” on page 8-29.
— MinHold
Displays the minimum response of the input signal at each
data point over multiple sweeps. See also Average Count in “Average
Count” on page 8-29.
— Average
Each data point is averaged over multiple sweeps as set by
the Average Count setting. Learn more in “Average Count” on
page 8-29.
— View
Displays and then holds the last complete measurement trace
on the screen. This is similar to storing a trace in memory.
— Blank
Displays no trace.
—Press Default All
to return all traces to their default settings: Trace 1
(Clear/Write); all other traces (Blank).
Trace 4 data WILL be overwritten by the FieldFox when using the
Independent Source Normalize feature (“Independent Source” on
page 8-18) or using Field Strength antenna or cable corrections (“Field
Strength Measurements” on page 8-12).