Keysight N9912A - NA (Network Analyzer) Mode

5- 1
Keysight Handheld Analyzers
N9912A User’s Guide
5 NA (Network Analyzer) Mode
Learn more about NA Mode measurements in the FieldFox Supplemental
Online Help:
http://na.support.keysight.com/fieldfox/help/SupHelp/FieldFox.htm.
In this Chapter
“Measurement Selection” on page 5-3
“Parameter Conversion” on page 5-3
“Quick Settings” on page 5-5
“Calibration Settings” on page 5-6
“Format” on page 5-7
“Frequency Range” on page 5-8
“Scale Settings” on page 5-8
“Magnitude Offset” on page 5-9
“Electrical Delay” on page 5-10
“Phase Offset” on page 5-10
“Averaging” on page 5-11
“IF Bandwidth” on page 5-12
“Smoothing” on page 5-12
“Single or Continuous Measure” on page 5-13
“Resolution (Number of Data Points)” on page 5-13
“Sweep Time” on page 5-14
“Output Power” on page 5-14
“System Impedance (Z0)” on page 5-15
“Port Extensions” on page 5-16
“Velocity Factor” on page 5-17