Keysight N9912A - Prefixes for Filenames

17- 10 Keysight N9912-90001 User’s Guide
File Management
Saving and Recalling Files
17-
Prefixes for Filenames
A prefix is used as a default filename to which characters can be added. The
prefix can be customized, and quickly enabled or disabled. When enabled, the
current prefix is automatically entered as the start of a filename when
performing a Save operation.
How to enable/disable the Prefix (persistent)
—Press Save/Recall 9.
—Then More
.
—Then Prefix ON
OFF. The current selection is underlined.
How to edit the current Prefix
—Press Save/Recall 9.
—Then More
.
—Then Prefix
.
— Then choose from the following:
—— Select
to add the cursor character to the end of the Prefix.
—— Back Space
to delete the last character(s) from the end of the
prefix.
——Clear
to erase the Prefix.
——The preselected keywords (File, Site, and so forth) can be
selected just like a single character. These keywords can also
be edited. See Edit Keywords.
How to move the cursor
— Use the rotary knob to move cursor on the same row.
— Use the arrows to move the cursor up and down the rows.
When the Prefix is complete
—Press Done to save the Prefix and close the labeler. This Prefix will exist on
the FieldFox until it is changed.
—Press Cancel
to close the labeler without saving changes.