18- 18 Keysight N9912-90001 User’s Guide
System Settings
System Configuration
18-
—Then press Ed it.
— Use the arrows or rotary knob to select the field to be edited.
— Use the arrows or numeric keypad to edit that field.
—Press Cancel
or Done when the edits are complete.
—Press Done
to exit the Date and Time settings. The readout in the
upper-right corner of the FieldFox screen will update accordingly.
LAN Settings
Configure the LAN settings to be used to communicate with the Data Link
Software. Learn more about Data Link at:
www.keysight.com/find/fieldfoxsupport.
How to configure LAN settings
The first three ‘Current...’ settings can NOT be edited.
—Press System 7
.
—Then System Configuration
.
Table 18-1 LAN LEDs (N9912A units with serial number prefixes ≥5607 Only)
LAN LEDs (N9912A units with serial number prefixes ≥5607 Only)
When FieldFox is connected to the LAN, the flashing LAN LEDs have the following
definitions:
Green: Flashing indicates packets are being transferred.
Yellow:
— Flash, pause = 10 Mbit link speed
— Flash, flash, pause = 100 Mbit link speed
— Flash, flash, flash, pause = 1 GBit link speed
To Next Page
Loading...
