14- 4 Keysight N9912-90001 User’s Guide
VVM (Vector Voltmeter) Mode - Option 308
VVM Mode Settings
14-
VVM Mode Settings
Select VVM Mode before making any setting in this section.
How to select VVM Mode
—Press Mode.
—Then VVM
.
Measurement Selection
How to select a VVM Measurement
—Press Measure 1.
— Then choose from the following:
— 1-Port Cable Trimming
1-port reflection measurement. Learn how to
make this measurement in “1-Port Cable Trimming Measurements ”
on page 14-9.
— 2-Port Transmission
2-port transmission measurement. Learn how
to make this measurement in “2-Port Transmission Measurements”
on page 14-11.
Frequency Selection
VVM measurements are made at a single CW frequency.
How to set Frequency
—Press Freq/Dist .
—Then Frequency
.
— Enter a value using the numeric keypad, the arrows, or the rotary
knob.
— After using the arrows or the rotary knob, press Enter
. The increment
setting of the arrows is based on the current span and can NOT be changed
in VVM Mode.
— After using the keypad, select a multiplier key. Learn about multiplier
abbreviations in“Multiplier Abbreviations” on page 2-14.
Frequency can be set to 1 Hz resolution.
To Next Page
Loading...
Need help?
General
