EasyManuals Logo

Keysight N9912A User Manual

Keysight N9912A
344 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #105 background imageLoading...
Page #105 background image
Keysight N9912-90001 User’s Guide 7- 9
Calibration for NA, CAT, and VVM Modes
Why and When to Calibrate
2. The Frequency Range, Resolution, Power (Hi/Low), and IF BW (in NA Mode)
settings of the two calibrations are identical.
When both conditions occur, you can switch between the 1-port and the
2-port measurements, and both will remain fully calibrated.
In a DTF measurement, the frequency range over which the calibration is made
can be viewed using the calculated Start and Stop Frequency on the Settings
page. Learn how to see this in “Calculated DTF values” on page 4-26.
Save the Calibration
After performing any type of calibration, you can save the FieldFox settings
along with the calibration into a STATE (*.sta) file. These settings and
calibration can then be recalled as necessary. To learn how, see “Saving and
Recalling Files” on page 17-2.

Table of Contents

Other manuals for Keysight N9912A

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keysight N9912A and is the answer not in the manual?

Keysight N9912A Specifications

General IconGeneral
BrandKeysight
ModelN9912A
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals