Keysight N9912A - Gps

18- 12 Keysight N9912-90001 User’s Guide
System Settings
System Configuration
18-
How to Install Options
A.lic file must already be on a USB Flash Drive. To learn how to obtain a.lic file,
visit: http://www.keysight.com/find/softwarelicense
Insert the USB Flash Drive in the FieldFox.
—Press System 7
.
—Then System Configuration
.
—Then Options
.
—Then Install Options
The FieldFox reads, validates, then installs the options.
— Press and hold the power button to shut down, then restart the FieldFox.
How to Delete ALL Options
Deleting individual options is NOT supported.
—Press System 7
.
—Then System Configuration
.
—Then Options
.
—Then Advanced
.
—Then Delete All Options
.
After a warning message, all options on the FieldFox are deleted.
GPS
GPS (Global Positioning System) allows you to ‘stamp’ each data trace with
your physical position in latitude/longitude/elevation format. This can be
useful when making measurements on cell towers or other antennas at remote
locations.
— GPS can be used in all FieldFox modes.
— Your GPS setting can be saved with Preferences. Learn more on page 18-7.
Delete All CFG Options is to be used by Service Personnel ONLY.
This feature is usable ONLY with the GPS receiver that is shipped with
Microsoft “Streets and Trips” and “AutoRoute” (versions 2010 and later).
The GPS receiver is NOT available from Keysight. Only the GPS USB
receiver is used with the FieldFox. Therefore, it is NOT necessary to
purchase the very latest version of the map software.