8. If you need rack mounting, attach
the two rack mounts. Tighten the
rack mounts using the screws
provided.
Depending on your rack
equipment placement
requirement, you can attach the
rack mounts to the front of the
chassis, or at an offset from the
chassis front.
Rack Mounts attached to the front of the chassis
Rack Mounts attached at an offset from the chassis front
9. Use the provided power cords to connect the chassis to the electrical power source.
Rack Mounting and Ventilation Warning
The XGS2 chassis are shipped with brackets and screws for rack mounting and rubber feet for
stationing on a flat surface.
Installing the XGS2 chassis in an Equipment Rack
1.
The equipment can be installed in most standard 19-inch racks and Telco two-post racks. To
install the unit in a rack, complete the following steps:
Chapter 2 XGS2 Chassis Physical Setup
– 12 –
To Next Page
Loading...