Initial Configuration XGS2-SD
To perform initial system configuration for the XGS2-SD chassis, do the following:
1.
Connect the monitor, USB mouse and keyboard, and then start the chassis.
2.
When the chassis boots up, log on to the chassis.
The user name is ixia and the password is the CPU module serial number found on the sticker
located at the back of the chassis.
3. Once you log on to the chassis, change the IP address.
Note: 10.0.x.x/16 is the default internal port address. This can be changed from IxExplorer
Chassis Properties.
Change IP Address
To change the IP address, do the following:
1. On the Start menu, select Control Panel.
2. Select Network and Internet and then select Network and Sharing Center. The View
your basic network information and set up connections window appears.
3. Under View your active networks, select the local area connection under Access type:
Internet. The Status window appears.
Chapter 3 XGS2-SD Configuration
– 17 –
To Next Page
Loading...