Step 5: Install the DMM Modules in the PXI Chassis
Keysight M9180 Series Startup Guide 25
– Slide the module completely into the chassis. When you begin to feel
resistance, push up on the injector/ejector handle to fully seat the module
into the chassis.
5 Latch the module by pulling up on the injector/ejector handle and secure the
front panel to the chassis using the module front-panel mounting screws.
6 Tighten the screws on the module (or remote controller) front panel.
Performance may suffer if the screws are not securely tightened.
7 Install all chassis covers, filler panels, and air scoops after installing the
module. Missing filler panels may disrupt necessary air circulation in the
chassis.
8 If you are using a remote controller, connect the Cable Interface Card in the
chassis to host computer.
9 Plug in and power up the PXI chassis. Verify that the chassis fans are operating
and free of obstructions that may restrict airflow.
10 If you are using a remote controller (rackmount, desktop, or laptop PC), reboot
the controller.
To Next Page
Loading...
