Step 6: Verify Operation of the DMM
26 Keysight M9180 Series Startup Guide
Step 6: Verify Operation of the DMM
Run Keysight IO Libraries Connection Expert
If Keysight Connection Expert is already running on the controller, click the
Refresh All button to identify any hardware you have just installed or
re-connected.
Locate your interfaces and instruments in the Keysight Connection Expert
Explorer Pane. Click on them to see their properties (displayed in the right-hand
pane). Observe their state, also displayed in the right-hand pane -- if
communication to the interface or instrument has been successfully established,
it will be in the Verified state, denoted by a green check mark.The following
illustration shows the Keysight Connection Expert.
If Connection Expert is not already running, run it now to verify your I/O
configuration: In the Windows Notification area, click the IO icon ( ), then click
Keysight Connection Expert.
To Next Page
Loading...
