Step 6: Verify Operation of the DMM
Keysight M9180 Series Startup Guide 27
You can use the Soft Front Panel (SFP) software to open and close the relays and
verify operation of the PXI DMM modules. The Soft Front Panel Software was
installed as part of the Software installation process.
Refer to the SFP help file on the Keysight M9180 Series PXI Digital Multimeters
Software and Product Information CD for specific detailed information on using
the SFP. The following graphic shows an example of the SFP for the DMM
modules.
Verify operation
To verify basic operational readiness, use the Soft Front Panel software to
configure and take a few basic measurements. For example, you could apply a
short across the input terminals and take a DCV measurement or 2W Ω
measurement. Both measurements should report values near zero. Module
specifications are guaranteed by design.
Conduct self test
Use the Utility menu on the Soft Front Panel software to run a module self test.
To Next Page
Loading...
