60 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
Block size has been adjusted to match
BlockSetSize / NumberOfBlks. But block size is not match to the
value exactly, please try another value.
-221 Settings conflict; Block size has been adjusted to match BlockSetSize
/ NumberOfBlocks.
Block size has been adjusted to match BlockSetSize /
NumberOfBlocks.
-221 Settings conflict; Block size of DCH{value} must match to
BlockSetSize / NumberOfBlks.
Block size must match to BlockSetSize / NumberOfBlks. The pointed
out DCH should be re-checked.
-221 Settings conflict; Burst cannot be on while using AM.
There is a hardware conflict for the burst envelope (I/Q menu) and
AM1/AM2. The most recently requested modulation will be turned on.
The previous modulation will be turned off.
-221 Settings conflict; The burst time values have been limited to match
the modulation settings.
The burst rise/fall time/delay values are dependent on the digital
modulation settings and may be limited as the modulation settings
change.
-221 Settings conflict; Calibration of the connected power sensor is not
available while a measurement is currently running
To Next Page
Loading...
