Keysight X-Series Signal Generators Error Messages 101
Error Messages
List of Error Messages
-220 Parameter error; Spread factor exceeds maximum allowable spread factor
The spread factor exceeds the maximum allowable spread factor. The
maximum allowable spread factor is currently 256.
-220 Parameter error; Spread factor not valid
The spread factor should be a power of 2 that is between 4 and 256.
-220 Parameter error; {name} The modulation type has been defaulted.
The specified file is not a modulation file type so the modulation
type has been defaulted.
-215 Arm deadlock
The arm source for the initiation of a measurement is set to
GET and a subsequent measurement query is received. The
measurement cannot begin until a GET is received, but the
GET would cause an INTERRUPTED error.
-214 Trigger deadlock
A trigger source for the initiation of a measurement is set to GET
and a subsequent measurement query is received. The measurement
cannot begin until a GET is received, but the GET would cause an
INTERRUPTED error.
-213 Init ignored
A request for a measurement initiation was ignored as another
To Next Page
Loading...
