12 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
Indicates that memory was exhausted during frequency precalculation
(used to speed the process of sweep/list mode). List mode cannot
run until either fewer frequencies have been supplied or more
memory becomes available and the same set of frequencies are sent
again, FREQ:MODE CW is executed, or :FREQ:MODE LIST is executed.
-321 Out of memory; Complementary Cumulative Distribution Display cannot
function.
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; Could not copy current istate.
An instrument state operation, such as save/recall, could not
allocate enough space to copy an instrument state. The operation is
aborted.
-321 Out of memory; Could not perform channelization code conflict test.
This error is reported when an attempt to check WCDMA DL channels
for conflicting channelization codes fails due to an out of memory
error.
-321 Out of memory; Display system out of memory. An abnormal display may
result. Memory consumption should be reduced.
There was not enough memory in the system to properly update the
display. Some inconsistencies may be seen. The size of any
list/sweep should be reduced, and the source should be preset to
clear up any inconsistencies. Report this error to service office.
To Next Page
Loading...
