Keysight N5183B MXG - List of Out of Memory Errors (-321) - Subsystems; Out of Memory: Subsystem Operation Failures

Keysight X-Series Signal Generators Error Messages 13
Error Messages
List of Error Messages
-321 Out of memory; FFT subsystem unable to function.
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; FIR subsystem unable to operate.
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; Front panel firmware upgrade unable to begin.
There is insufficient working memory available. Report this error
to service office. The front panel firmware was not successfully
upgraded, but it was not corrupted either.
-321 Out of memory; Graph subsystem cannot function.
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; Histogram display cannot function
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; Impulse response display cannot function.
There is insufficient working memory available. Report this error
to service office.
-321 Out of memory; I/Q map display cannot function.