Keysight X-Series Signal Generators Error Messages 147
Error Messages
List of Error Messages
700 State Save Recall Error; Recalled state has a bad checksum. No
instrument state change. {name}
The state file was corrupt or out-of-date, so the recall was
ignored. If state file exists, delete explicitly using the memory
catalog.
700 State Save Recall Error; Save state ignored as the save recall
registers could not be written.
The instrument could not save an instrument state because it could
not write out the information of which save/recall registers are in
use. Previous error messages may make why this error was reported
clear.
700 State Save Recall Error; Unable to delete saved state. No instrument
state change.
Could not delete a saved state. Previous error messages may make
why this error was reported clear.
702 Load/Store Error; Cannot create a filter with an odd number of
coefficients for a complex filter or a non-multiple of 4 for a general
filter.
A filter specification cannot have partial taps -- it must have an
even number of coefficients for a complex filter or a multiple of 4
coefficients for a general filter.
702 Load/Store Error; Cannot create a filter with no coefficients.
To Next Page
Loading...
