154 Keysight X-Series Signal Generators Error Messages
Error Messages
List of Error Messages
causes, then the module may need to be reset by turning it off then
on. This will set up the clock modules properly.
811 Digital module trigger FIFO overflow error; There are more samples
being produced than can be consumed at the current clock rate. Verify
that the digital module clock is set up properly.
This error is reported when the digital module clock setup is not
synchronized with the rate the samples are entering the digital
module. Verify that the input clock rate matches the specified
clock rate under the clock setup menu.
812 Digital module trigger FIFO underflow error; There are not enough
samples being produced for the current clock rate. Verify that the
digital module clock is set up properly.
This error is reported when the digital module clock setup is not
synchronized with the rate the samples are entering the digital
module. Verify that the input clock rate matches the specified
clock rate under the clock setup menu.
To Next Page