Keysight X-Series Signal Generators Error Messages 47
Error Messages
List of Error Messages
-223 Too much data; The current setting results in too many data points. A
new symbol map cannot be generated. The current channel has been
restored to its previous type.
Due to hardware limitations, only a certain number of unique data
points can be created for the IQ map. This channel type, together
with its power setting, has exceeded that limit. The channel type
reverts to its previous type to retain a valid signal. To try a
different power setting, turn the channel off, switch to the
desired type, change the power setting, and then turn the channel
back on.
-223 Too much data; The current setting results in too many data points. A
new symbol map cannot be generated. The format has been turned off.
Due to hardware limitations, only a certain number of unique data
points can be created for the IQ map. CDMA2000 or 1xEV-DV mode
turns off when the power combination of all channels exceed that
limit. Adjust the channel power level and try again. Due to
hardware limitations, only 256 unique data points can be created
for the IQ map. WCDMA mode turns off when the power combination of
all channels exceeds that limit. Adjust the channel power level and
try again.
-223 Too much data; The current setting results in too many data points. A
new symbol map cannot be generated. The IQ Rotation has been restored
to previous value.
Due to hardware limitations, only a certain number of unique data
points can be created for the IQ map. IQ rotation is designed to
alleviate this problem, but incorrect use can result in undesirable
To Next Page
Loading...
