Keysight N5183B MXG - Settings Conflict Errors (-221) - Sequence Lists, Triggers, and Skew; Sequence List, Trigger Type, and Skew Conflicts

Keysight X-Series Signal Generators Error Messages 91
Error Messages
List of Error Messages
modulation and pulse modulation. The most recently requested
modulation will be turned on. The previous modulation will be
turned off.
-221 Settings conflict; The selected Eb Ref channel which 3GPP Uplink AWGN
refers to must be on.
The physical channel to which the AWGN Eb Ref refers is off. Turn
the channel on.
-221 Settings conflict; Sequence list not specified
A list sweep was attempted but there was no list specified.
-221 Settings conflict; SINGle trigger type is not allowed if data type is
not PN or EXT. Trigger type has been set to CONTinuous.
SINGle trigger type does not work with PRAM data types (not PN or
EXT).
-221 Settings conflict; Skew cannot be enabled until the skew adjustment
has been completed.
Skew cannot be enabled until the skew adjustment has been
completed.
-221 Settings conflict; Skew cannot be enabled when filters are active that
exceed a length of 32 symbols.
Skew cannot be enabled when filters are active that exceed a length
of 32 symbols.