6 Installation Note N9030-90045
Option BBA, Analog Baseband I/Q Inputs Retrofit Kit
Tools Required
❏ PXA Service Guide as N9030A-0BW or N9030-90030
❏ T-10 Torx Driver
❏ T-20 Torx Driver
❏ 5/16-inch torque wrench
❏ 1/4-inch open end wrench
❏ 1/4-inch socket on 4 lb torque wrench
❏ scissors or knife
❏ diagonal cutters
❏ USB storage device with > 2 GB free memory
WARNING Before you disassemble the instrument, turn the power switch to Standby,
wait until the instrument has completely shut down, and unplug the
instrument. Failure to unplug the instrument can result in personal injury.
CAUTION Electrostatic discharge (ESD) can damage or destroy electronic components. All
work on electronic assemblies should be performed at a static-safe workstation.
Refer to the documentation that pertains to your instrument for information about
static-safe workstations and ordering static-safe accessories.
Agilent Service Center or Customer Calibration Lab:
The following kit items are not installed in the analyzer upgrade and need to be shipped back to the
end user for their use:
• USB storage device
• 5063-2143, Probe tip BNC adapter
• 8120-2682, cable
• Entitlement Certificate
To Next Page
Loading...
Need help?
General
