Table Of Contents
9.2.3 *ESE - Standard Event Status Enable 2423
9.2.4 *ESR? - Standard Event Status Register Query 2424
9.2.5 *IDN? - Identification Query 2424
9.2.6 *OPC? - Operation Complete 2425
9.2.7 *OPT? - Query Instrument Options 2426
9.2.8 *RCL - Recall Instrument State 2426
9.2.9 *RST - Reset 2426
9.2.10 *SAV - Save Instrument State 2427
9.2.11 *SRE - Service Request Enable 2427
9.2.12 *STB? - Status Byte Query 2428
9.2.13 *TRG - Trigger 2428
9.2.14 *TST? - Self Test Query 2428
9.2.15 *WAI - Wait-to-Continue 2429
9.3 SCPI Operation and Results Query 2430
9.3.1 Mode Control 2430
9.3.2 Measurement Control 2430
9.3.2.1 CONFigure 2431
9.3.2.2 INITiate 2432
9.3.2.3 FETCh 2432
9.3.2.4 READ 2433
9.3.2.5 MEASure 2434
9.3.3 Trace Formatting Commands 2435
9.3.3.1 Clear Trace (Remote Command Only) 2435
9.3.3.2 Send/Query Trace Data (Remote Command Only) 2436
9.3.3.3 Format Data: Numeric Data (Remote Command Only) 2438
9.3.3.4 Format Data: Byte Order (Remote Command Only) 2439
9.3.3.5 Calculate/Compress Trace Data Query (Remote Command
Only) 2439
9.3.3.6 Calculate Peaks of Trace Data (Remote Command Only) 2445
9.3.3.7 Smooth Trace Data (Remote Command Only) 2447
9.3.3.8 Number of Points for Smoothing (Remote Command Only) 2448
9.3.3.9 Mean Trace Data (Remote Command Only) 2449
9.4 Status Register System & STATus Subsystem 2450
76 Short Range Comms & IoT Mode User's &Programmer's Reference
To Next Page
Loading...
