3-8 Keysight Technologies Startup Guide
Safety and Regulatory Information
Regulatory Information
3-
To prevent electrical shock, disconnect the AC to DC adapter from
the mains before cleaning. Use a dry cloth or one slightly dampened
with water to clean the external case parts. Do not attempt to
cleans internally.
When the is connected to the AC/DC adapter, position the adapter
so the power cord is readily accessible. The power cord is the
disconnecting device. It removes main power to the AC/DC adapter.
The front panel switch is only for the DC power within the
instrument, and not for the AC/DC adapter. Alternately, an AC
switch or circuit breaker (which is readily identifiable and is easily
reached by the operator) may be installed and used as a
disconnecting device to remove mains power from the AC/DC
adapter.
The AC/DC adapter has an auto–ranging line voltage input – be sure the
supply voltage is within the specified range.
The AC/DC adapter is for indoor use only.
Never use a modified or damaged charger. Use the original AC–DC
adapter ONLY.
The AC/DC adapter is designed for use in Installation Category II and
Pollution Degree 2 per IEC 61010-1.
To Next Page
Loading...
Need help?
General
