Keysight U1177A - Operation; Connect Your U1177 A Adapter to the Multimeter; Set up the U1177 A with a Computer Bluetooth Connection

Operation
Connect Your U1177A Adapter to the Multimeter
Snap the optic side of the U1177A to the multimeter IR communication port.
Set Up the U1177A with a Computer Bluetooth Connection
• Before you begin, make sure the Bluetooth connection on your PC is ena-
bled.
• It is recommended to use brand new batteries before running any opera-
tions that are critical or require a longer duration.
1. Set the U1177A slide switch to On.
2. From your PC, go to Start > My Computer > My Bluetooth Places.
3. Click Add a Bluetooth Device to open the Bluetooth Setup Wizard.
4. Click Next>. The Bluetooth Device Selection will display a list of bluetooth devices.
5. Select Keysight U1177A-XXXXXX—the XXXXXX represents U1177A device ID
—and click Next>.
6. In the Pair Now tab, type the default Bluetooth security code “1234” and click Pair Now.
7. Once pairing is successful, check SPP as your selected Bluetooth service and click Next>.
8. A shortcut display notication pop-up window will appear. Click OK.
9. Upon completion of the Bluetooth Setup Wizard, rename the device if required.
10. Click Finish to complete the connection. The U1177A-XXXXXX is now added and
connected successfully.
11. If you already had the U1177A added in My Bluetooth Places, double-click U1177A to
establish a wireless serial connection with your remote multimeter.
12. Double-click U1177A again to disconnect the wireless serial connection.
In some cases, the Bluetooth Device Manager will create two COM ports. Use
the COM port with the “Outgoing” label only.
4